We don't resell pumps — we cast, machine and ship them. That is why operators in 60+ countries use Matec wet ends as direct replacements for Warman® pumps and parts.
15,000 t annual alloy casting + 5,000 t moulded rubber under one roof. From melt to machined wet end, quality is controlled in-house.
Every impeller, liner and throat bush is dimensioned to match Warman® wet-end geometry. No retrofit. No field modification.
High-chrome, natural & synthetic rubber, polyurethane and composites — selected by your slurry, not by catalogue.
Material and workmanship warranty that follows the part. That is our core differentiator against budget aftermarket suppliers.
Supplying pumps and wear parts to concentrators, aggregate plants and dredging contractors across 60+ countries.
Four pump families with matched wet-end spare parts — fully Warman®-interchangeable.
Horizontal
Heavy-duty centrifugal pumps for mill discharge, cyclone feed and tailings. MHM / MHR / MHH / MM / MR / MLM / MLR series.
View range →
Sand & Gravel
MG / MGH high-volume series for dredging, sand, gravel and coarse abrasive slurries.
View range →
Vertical
Sump and tank-mounted designs for dewatering, sump and tailings duties. Interchangeable with Warman® SP / SP(R) series.
View range →
Submersible
MSP electric submersible units for pit dewatering and abrasive sumps where a dry-installed pump is impractical.
View range →Purpose-built solutions across the mineral processing chain.
The Pump 650 throatbush was failing at 1,800–2,200 h while the rest of the wet end lasted 3,000–3,500 h. Our Duramic™ composite throatbush — identical geometry, no field modification — now reaches end-of-service with the rest of the set, turning unscheduled change-outs into one planned maintenance event.
Read case studies →High-chrome wet-end set re-graded to actual duty — longer impeller intervals, lower parts cost per tonne.
Heavy-section wet end and staged seal arrangement stabilised a long-distance tailings disposal line.
A05-equivalent high-chrome wet end — noticeably longer impeller intervals vs original.
Trial install with material certificates and dimension reports — wear data cleared the way to a site-wide repeat order.
Send us your duty point and current pump model — we return a matched solution and price.
Contact Us